1 Station Electrical Appliance Tester 220V Label Marking Abrasion IEC60730-1

1 Station Electrical Appliance Tester 220V Label Marking Abrasion IEC60730-1

Production introduction:

This testing apparatus is design and manufactured according to IEC60730-1 standard figure 8 and annex A requirements, used for testing the controller marking durability performance.

The apparatus comply with the dimensions requirements of IEC 60730-1 Figure 8. Test times can be set from 1 to 999999 (default as 12 times), test rate 48 rpm. It is a easy operated professional equipment.

Main technical parameters:

Equipment	Markings durability tester
Test station	1 station
Test stroke	20mm
Test rate	48rpm
Test times	1~999999, default as 12times
Sliding weight	500g. Strip weight 250g, with weight 750g
Brass washer	Φ60*2.5mm
Friction wheel	Φ65*7.5mm
Power supply	220VAC 50Hz
Standard	IEC 60730-1 Figure 8, Annex A

Test Operation

1. Test Preparation: Insert the power supply ,turn on the power supply switch ,preset the test times as 12 times .
2. Select the corresponding weight to install the sample.
3. Press start button , the device reciprocates at a rate of 48 rpm and a stroke of 20mm ,it will be automatically stop when reaches the test times .The stop button lights and sound an alarm .

Presetting and parameters of instrument

Counter/Timer: Press down [MD] for three seconds to enter setting state→ the display mode is[IN]→press ▲or ▼to select [U]mode →repress [MD]→the display mode is [CPS]→press ▲ or ▼to select [30]→this analogy→ finally press down [MD]for three seconds to complete the setting procedure. Press
Counter
Input mode IN	U		Input logic SG	PNP
Counting speed CPS	30		再保险setting time RST	20
Output mode OUT	F		Counting/Timer C-T	COUN
Output time OUT.T	HOLD